ECS H61H2-I5 Manual page 50

Step4. Installation of storage devices:
4-1. Please remove the front cover and
5.25'' plate from the case.
Step5. Case Preparation and Installation of Power Supply:
Remove both sides and the lid of the case, and then install
the power supply with screws.
It is recommended to use a power supply delivering
more than 300W of power. Insufficient power supply
may cause unstable boot-up.
Step6. Installation of an Expansion card:
Remove the metal located on the slot and then insert the
expansion card into the slot. Press the card firmly to make
sure it is fully inserted into its slot. And then return the
screw back to its position.
Step7. Connecting Cables and Power Connectors:
a. Connect the SATA hard drive to its
SATA cable
c. Connect 24-pin power cable
Please note that when installing 24-pin
power cable, the latches of power cable
and the ATX connector match perfectly.
46
4-2. Place the storage devices (IDE/
SATA/FDD) in its position within the case
and secure the device with screws.
b. Connect SATA power connector to the
SATA device
d. Connect 4-pin power cable
The ATX_12V 4-Pin power connector is used
to provide power to the CPU. When installing
4-pin power cable, the latch of power cable
matches the ATX_12V connector perfectly.