Table of Contents
Advertisement
INSTALLING THE DRYER
Step 3 : Connect Gas Supply Pipe
(Gas Dryer ONLY)
For further assistance, refer to section on Gas
Requirements.
1. Make certain your dryer is equipped for use with the
type of gas in your laundry room. Dryer is equipped at
the factory for Natural Gas with a 3/8" N.P.T. gas
connection.
2. Remove the shipping cap from the gas connection at
the rear of the dryer. Make sure you do not damage the
pipe thread when removing the cap.
1
New Stainless Steel Flexible Connector -
Use only if allowed by local codes (Use
Design A.G.A. Certified Connector)
2
1/8" N.P.T. Pipe Plug (for checking inlet
gas pressure)
3
Equipment Shut-Off Valve-Installed
within 6' (1.8 m) of dryer
8
3. Connect to gas supply pipe using a new flexible
4. Tighten all connections securely. Turn on gas and
5. For L.P. (Liquefied Petroleum) gas connection, refer
1
2
5
3
4
4
5
Fig. 1
stainless steel connector.
check all pipe connections (internal & external) for
gas leaks with a non-corrosive leak detection fluid.
to section on Gas Requirements.
Black Iron Pipe
Shorter than 20' (6.1 m) - Use 3/8" pipe
Longer than 20' (6.1 m) - Use 1/2" pipe
3/8" N.P.T. Gas Connection
Advertisement
Table of Contents
