Mazda 2009 MX-5 Miata Owner's Manual page 257

When the seek tuning button (
pressed (about 1.5 seconds), playback
starts from the beginning of the current
program.
When the seek tuning button (
pressed twice, playback starts from the
beginning of the previous program.
When the seek tuning button (
pressed for about 1.5 seconds or longer,
the program is reversed while the button
is being pressed.
When the seek tuning button (
pressed (about 1.5 seconds), playback
starts from the beginning of the next
program. When the seek tuning button
( ) is pressed (about 1.5 seconds) while
the last program is being played, the
instant replay mode is cancelled.
When the seek tuning button (
pressed for 1.5 seconds or longer, the
program is fast-forwarded while the
button is being pressed. When pressing
and holding the button until the end of the
program, the instant replay mode is
cancelled.
When the instant replay button is pressed
again, playback is paused, or playback
starts if it has been paused.
Instant replay (PAUSE)
If the instant replay button is pressed
while the instant replay mode is off,
instant replay mode is turned on in a
paused condition (PAUSE). Press the
instant replay button again to resume
playback from the point at which it was
paused.
NOTE
If the channel is changed, the instant replay
l
buffer data is deleted.
After turning on the power and switching to
l
SIRIUS digital satellite radio mode, the
instant replay mode is not available for
several seconds after changing channels.
) is Displaying the SIRIUS ID (ESN)
When the ESN button is pressed for 1.5
seconds or longer, a 12-digit Electronic
Serial Number (ESN) for the SIRIUS
) is
tuner is displayed.
(If the SIRIUS ID (ESN) for the tuner
) is
does not display)
If ESN
pressing the ESN button for 1.5 seconds
or longer, contact an Authorized Mazda
) is
Dealer.
Initialization of ID code
If the registered ID code is forgotten,
return the ID code to the default [0000] by
performing the following steps:
Setting condition: SAT mode
) is
(Master code input preparation)
1. Hold the scan button, then press
2. ENTER PIN appears for three
3. SR1 - - - - appears, which indicates
(Master code input)
4. Input the master code using the channel
(Master code input determination)
5. Determine the master code which has
6. PIN CLEARED appears which
FAIL is displayed after
channel preset button 4, hold both
buttons together for 1.5 seconds.
seconds which indicates that it is in
code input mode.
that it is ready for code input.
preset buttons 1-4.
(The master code is already set at the
time of factory shipment.)
been input by pressing the scan button.
indicates that the master code input has
been completed.
Interior Comfort
Audio System
6-41