Advertisement
Se ,ce
Yr IG
Instruction
Sheet
16008915
2707490-0200
This instruction
sheet is to be used with :
REPAIR
PART
NO.
:
12001454,
12001725
DESCRIPTION
:
Machine
Control
Board Kit
II
II II
II
This
kit contains:
22002988
Machine
Control
Board
16002292
Schematic
22002335
Jumper
Wire
(Red Wire
No. 3)
16008915
Instruction
Sheet
22002281
Pilot Lamp
(Yellow
based)
I
I
The following
chart will depict which components
apply to the washer you
are servicing.
i
Model Number
MAH300OAWA
MAI_000AWQ
MAH3000A_
Prior to Series 17
A
A
A
Series 17 & Later
B
B
B
84.iDE BOARD - LEFT
= Use all components
and follow instruction steps 1 - 11 below.
B = Use only the 22002988
board and follow instruction steps 1,2, 9, 10 & 11 below.
Procedure:
1.unplug the washer.
Z Remove the three screws securing the rear
console cover plate to the console and lay
the console forward carefully onto a sen,ice
blanket on the top cover.
3. Locate the ON Lightin the console and remove
the Black No. 3 wireand theWhite
,'Jo. 11
wire from the signal lamp assembly. Unsnap and
discard the ON Light lamp assembly.
4. Fold the Black No. 3 wire back and tape the wire
to the main harness out of the way.
5. Locate and remove connector P7 from the left
side of the Machine Control board.
6. Insert the jumper wire (Red Wire No. 3), found in
the service repair assembly, into position
number 5 of the P7 connector, then reconnect the
P7 connector beck onto the Machine
Control Board.
7. Remove the Yellow based indicator lamp found in
the service assembly and position the
lamp where the previous ON Light lamp assem-
bly was previously removed.
Then snap the new
lamp assembly into the console.
8, Connect the White No. 11 wire and the Red No. 3
wire to the new yellow based lamp assembly.
9, Remove the existing electrical schematic taped to
the rear wall of the console and replace
with the electdcal schematic found in the service
assembly.
lO,Reposition
the console into the updght position
on the topcover and secure the three
screws fastening the console to the rear console
cover plate.
11.Replacement
is complete.
Advertisement
