Preparation For Use - Echo CS-8000 Operator's Manual

Bolt (A)
Front hole (B)
Front hole (C)
Nut (F)
Chain brake lever
(Front hand guard)
Clutch cover
Two nuts
Nuts
Two bolts 6 × 20 mm and washers
CS-8000 TYPE1-E

PREPARATION FOR USE

Dimple (D)
Kick Guard
Recess (E)
Guide bar
Spiked bumper
Two bolts 6 × 14 mm
Spiked bumper
Saw chain is sharp! Always wear gloves
when handling assembly, otherwise serious
personal injury may result.
KICK GUARD
INSTRUCTIONS
Tools Needed: Two 11 mm (7/16 in.) Wrenches.
For saws with Kick Guard
Symmetrical Low-Kick type (Double Guard)
guide bars.
1. Install bolt (A) in front hole (B) of Kick Guard
and through front hole (C) in guide bar.
®
2. IMPORTANT: Dimple (D) in Kick Guard
engage recess (E) in guide bar.
3. Tighten nut (F) and bolt (A) using 11 mm (7/16 in.)
wrenches until snug. Make certain Kick Guard
is flush against guide bar.
4. Tighten nut (F) 1/8 additional turn.
5. Check to make certain Kick Guard
guide bar.
GUIDE BAR AND SAW CHAIN
INSTALLATION/REMOVAL
NOTE
Move the chain brake lever (Front hand guard)
fully rearward to remove or install the clutch
cover to chain saw.
1. Remove spark plug lead. (See page 24)
2. Remove two clutch cover nuts and remove clutch
cover.
3. Remove bar and saw chain if necessary. See
"Maintenance and Care" section for guide bar/
saw chain maintenance procedures.
4. For initial setup, install spiked bumpers - one on
front of machine with two 6 × 14 mm bolts and
one on clutch cover with two 6 × 20 mm bolts,
washers and nuts each.
10
WARNING
®
TO BAR
®
P/N 2893201 and
®
must
®
is tight on
®
®