Advertisement
English
Our products are designed to meet the highest standards of quality, function-
ality and design. We hope you enjoy your new Braun shaver.
Warning
• Keep the appliance dry.
• For safety reasons, periodically check the cord for damage and replace it,
if it is loose in the shaver socket.
1 Description
1 Foil protection cap
2 Shaver foil
2a InterFace trimmer
3 Cutter block
4 Release button
5 Pop-out long hair trimmer
2 Charging the shaver
• When charging for the first time: Connect the shaver to the mains and charge
it for at least 4 hours (switch position «off»). Then shave without the cord until
the batteries are fully discharged. Then recharge to full capacity again
(subsequent charges will take about 1 hour).
• The green charging light shows that the shaver is being charged. When the
rechargeable battery is fully charged, the charging light goes off. If later on,
the charging light comes on again, this indicates that the shaver is being
recharged to maintain its full capacity.
• A full charge will give up to 30 minutes of cordless shaving time depending on
your beard growth. However, the maximum battery capacity will only be
reached after several charging/discharging cycles. Best environmental tem-
perature range for charging is 15 °C to 35 °C.
• Wattage: 4 Watts
Voltage range during charging: 12–240 V2/ 50 or 60 Hz
(automatic adaptation)
3 Shaving
3.1 Switch positions
off
foil shave
combi shave
4
6 Switch
7 Charging light
8 Shaver socket
= Switch is locked.
= Shaver foil only.
= Combination shave (InterFace trimmer works in tandem
with the shaver foil to first cut the longer problem hairs,
which then allows the foil to shave the shorter hairs even
closer) (b).
Advertisement
