Jump Starting; Jump Starting - North America; Eassist Only) - Buick 2016 LaCrosse Owner's Manual

298 Vehicle Care

Jump Starting

Jump Starting - North
America (On-board with

eAssist Only)

If the vehicle fails to crank, it may
be jump started by using the eAssist
battery to charge the 12-volt battery.
Use the following procedure to
activate the on-board jump start
using the DIC controls.
DIC Buttons
The vehicle may be equipped with
an ignition key or an electronic
keyless ignition with pushbutton
start.
Key Access
Place the ignition key in the ON/
RUN position and proceed as
follows:
1. Press then scroll
until the Settings menu
displays.
2. Press to enter the
Settings menu.
3. Press then scroll
until Jump Start displays.
4. Press to activate the jump
start.
5. The system will then ask for
confirmation. If Yes is selected,
the jump start will begin and
the display will show WAIT TO
START.
6. When the jump start is
complete, the display will show
ATTEMPT START or JUMP
START DISABLED.
Keyless Access
With the brake pedal not applied,
press and hold the ENGINE START/
STOP button for more than
five seconds. This will place the
y z
or
vehicle in the Service Only Mode.
Proceed as follows:
1. Press
until the Settings menu
displays.
y z
or
2. Press
Settings menu.
3. Press
until Jump Start displays.
4. Press
start.
5. The system will then ask for
confirmation. If Yes is selected,
the jump start will begin and
the display will show WAIT TO
START.
6. When the jump start is
complete, the display will show
ATTEMPT START or JUMP
START DISABLED.
y z
then scroll or
to enter the
y z
then scroll or
to activate the jump