Operation; Barrel; Rotating The Barrel Assembly; Framing Shutters - Chauvet Ovation Min-E-10WW User Manual

4. O
PERATION

Barrel

Rotating the
Barrel Assembly

Framing Shutters

Gobo Holder Slot

Gobo Holder

Barrel
Assembly/Gobo
Holder Diagram

Lens Tube

Manual Beam
Focus Control

Gel Frame Holder

OVATION™ Min-E-10WW User Manual Rev. 2
The barrel is the section of the OVATION™ Min-E-10WW where the gobo holder slot and
framing shutters are. The lens tube is also attached here.
The OVATION™ ED-190WW allows manual rotation of the barrel assembly, as follows.
1. Locate the barrel rotation knobs at the top and bottom of the reflector housing.
2. Loosen the knobs by turning them counter-clockwise.
· Note: Do not remove the knobs.
3. Rotate the barrel to the desired position, up to 25° in either direction from the centered
position.
4. Tighten the knobs by turning them clockwise, which lock the barrel's position.
Make sure the barrel assembly is oriented with the gobo holder slot at the top of the
product.
Use the framing shutters to tighten and shape the beam of the OVATION™ Min-E-10WW, or
open them completely to allow the full beam to pass.
The gobo holder slot has a sliding cover and is located in front of the top framing shutter. The
cover can either block the slot completely when the gobo holder is not inserted, or lock the gobo
holder in place. Use a phillips head screwdriver to loosen or tighten the cover.
The OVATION™ Min-E-10WW comes with a removable gobo holder. Care must be taken when
removing or inserting the gobo holder. Follow the guidelines below when changing gobos:
·
Always insert the gobo holder with the handle facing towards the front of the product. The
heads of the rivets will also be facing the front of the product.
·
Pull back the framing shutter assembly directly behind the gobo holder slot for easier
insertion and removal.
·
Do not insert the gobo holder backwards.
Gobo Holder Slot
Cover Screw
The OVATION™ ED-190WW has a manual focus, which is adjusted as follows.
1. Locate the beam focus knobs at the top and bottom of the barrel assembly.
2. Loosen the knobs by turning them counter-clockwise.
3. Slide the lens tube forward or backward until you achieve the desired focus or beam edge.
4. Tighten the knobs by turning them clockwise, which lock the lens tube's position.
The OVATION™ Min-E-10WW comes with a removable gel frame that fits into the holder on the
front of the lens tube. To open the gel frame holder, pull the sides of the clip to the left and right
and flip it up.
The frame can only fit into the holder with the opening facing down.
Gobo Holder
Rivet heads

Operation

Handle face
-7-