Control Panel And Features - Whirlpool WTW4715EW Use And Care Manual

Control Panel and Features

1
1 SOIL LEVEL
Select the setting most suitable for your load. For heavily
soiled and sturdy fabrics, select Heavy Soil Level for more
wash time. For lightly soiled and delicate fabrics, select Light
Soil Level for less wash time. A lighter soil-level setting will
help reduce tangling and wrinkling.
RINSE OPTIONS
2
This option is used to add additional rinse cycles.
3 WASH CYCLE KNOB
Use the Wash Cycle knob to select cycles on your washer.
See "Cycle Guide" for detailed descriptions of cycles.
4 START/PAUSE BUTTON
Press to start the selected cycle; press again to pause the
cycle and unlock the lid.
NOTE: If the washer is spinning, it may take several minutes
to unlock the lid. Press and hold for 3 seconds to cancel a
cycle.
5
PROGRESS LIGHTS
The Progress Lights show the progress of a cycle. At each
stage of the process, you may notice sounds or pauses that
are different from traditional washers.
SENSING/FILL
When the START/Pause button is pressed, the washer will
fill to an initial water level and begin sensing to determine
the load size. The washer will then continue filling to the
appropriate water level based on load size and proceed
to Wash.
If the lid is opened or the START/Pause button is pressed,
the cycle will pause. Closing the lid and/or pressing the
START/Pause button will resume the cycle. If the cycle
remains paused with the lid open for 10 minutes, the
washer will pump out the water.
WASH
You will hear the agitator moving the load. The motor
sounds may change at different stages in the cycle. Wash
time is determined by the selected soil level.
RINSE
You will hear sounds similar to the wash cycle as the
washer rinses and moves the load. You may hear the
motor turning on briefly (short hum) to move the basket
while filling.
4
2
Not all features and options are available on all models.
Appearance may vary.
3
5 4
SPIN
The washer spins the load at increasing speeds for proper
water removal based on the selected cycle.
DONE
Once the cycle is complete, this light will come on. For
best results, remove the load promptly.
LOCKED
The Lock feature allows for higher spin
speeds. When lit, the lid is locked and
cannot be opened without pausing the
cycle. When the light is off, the lid can be
opened.
To open the lid after it has been locked,
press START/Pause. The lid will unlock
once the washer movement has stopped.
This may take several minutes if the load
was spinning at high speed. Press START/
Pause while the lid is closed to resume the
cycle.