Adjusting Reversing Sensor(S) - Chamberlain Elite SL3000UL Owner's Manual

A D J U S T I N G R E V E R S I N G S E N S O R ( S )
Adjust the "Reverse Sensor" on the control board. Alarm Sensor does not need to be adjusted except where noted below.
Sensor is set too sensitive
Sensor is not set sensitive enough
D C 2 0 0 0 ™ R e v e r s e S e n s o r
The DC2000™ has a separate reverse sensor that will need to be adjusted. The 120 Vac
operator power needs to be turned off and the DC2000™ should have the
LED ON to make the adjustment.
The level of reverse sensitivity depends on the weight of the gate
and the condition of installation.
= if the gate stops in midcycle or reverses by itself.
Maximum
Sensitivity
1 3
= if the gate hits an object and does not stop or reverse.
CENTER
Minimum
Sensitivity
W4
G B
MS LINK
"Charge OK"
29
SAFETY EXIT
A
SYSTEM O
SENSORS
1 3 1 3
FIRE STRIKE
DEPT
EXIT SAFETY
LOOP
DC-BACKUP
T MER
POWER
60 3
OVERLOAD
3
OFF ON
MADE IN USA
OPEN LEFT OPEN RIGHT
RAD O GATE
OPEN RECEIVER LOCKED
CENTER RESET
LOOP LOOP MOTOR
Maximum
Sensitivity
Minimum
Sensitivity