SECTION 7—CASTERS
Dust Cover
Locknut
Nylon Washer
Caster Headtube
Front Caster
and Fork
FIGURE 7.1 Replacing/Adjusting Front Forks
Replacing Front Casters
NOTE: For this procedure, refer to FIGURE 7.2.
1. Remove the hex screw, washers and locknut that secure the front caster to the fork.
2. Install the new front caster onto the transport chair by reversing STEP 1.
3. Repeat STEPS 1-2 for the opposite front caster if necessary.
Fork
Locknut
Hex Screw
Front Caster
NOTE: Dust cap not shown.
FIGURE 7.2 Replacing Front Casters
30
Transport Chairs
Part No.1125095