Assembling Belt And Pulley Guard; Assembling Switch - Delta 28-255 Instruction Manual

ASSEMBLING B ELT
A N D PULLEY G U A R D
Assemble belt and pulley guard (A) F i g . 1 7 , t o t h e t o p o f
t h e s tand and surrounding the driven pulley with two
3/4-20 x 5/8 hex head screws, flat washers and hex
n u ts ( B ) .

ASSEMBLING SWITCH

1 . M A K E C E R TAIN T H E B A N D S AW I S D I S C O N-
N E C T E D F R O M TH E P O W E R S O U R C E.
2 . CAUTION: T H E ON/OFF SWITCH-TO - M O TO R
CORD (F) FIG. 1 8 , I S TIED TO VERTICAL MOUNTING
P O S T (G) OPPOSITE T H E M O TO R P U L L E Y.THIS
C A B L E TIE (H)PREVENTS T H E SWITCH-TO-MOTO R
C O R D (F), FROM C O N TACTING THE BELT O R M O TO R
PULLEY DURING O P E R ATION. IMPORTA N T:D O N O T
R E M O V E THIS C A B L E TIE UNLESS Y O U A R E USING
T H E A C C E S S O RY #28-984 HEIGHT ATTA C H M E N T
WITH T H E B A N D S AW .
3 . Remove two outer hex nuts and lock washers (A)
Fig. 19, from the two screws extending out from the back
of the switch box (B).
4 . Insert two screws (C) Fig. 19, located on back of
switch box, into two holes (D) located in the band saw
arm.
5 . Fasten the switch box (B) to the band saw arm using
two hex nuts and lockwashers (A) Fig. 20, which were re-
moved in STEP 3.
B
C
A
D
Fig. 19
A
9
Fig. 17
Fig. 18
Fig. 20
B