Installing Color Touch-Screen Display; Inserting Or Changing The Needle - Baby Lock Tiara III BLTR16-3 Instruction And Reference Manual

Installing the Color Touch-Screen Display
The color touch-screen display comes pre-installed on
its mounting bracket and should have one end of the
D cable attached to the back of the touch screen (see
Figure 7).
 NOTE: Confirm that the power is turned off
before installing the touch-screen display.
1. Remove the two long bolts from the bag in which they
are packed.
2. There are three holes on top of the machine head
(see page 11, Figure 3, #19). Only the two holes that
are in line wth each other are used. Ignore the third
hole located to the side of these two holes.
3. Align the holes in the color touch-screen bracket with the two holes on top of the machine, with the touch-
screen display facing the needle end of the machine.
4. Use a 5mm Allen wrench to insert the two long bolts through the holes of the bracket and into the machine
(Figure 7). Tighten in place.
5. Plug the remaining cable end into the display connector located on the side of the machine (see page 11, Figure
3, #23).
6. Carefully remove the protective plastic from the touch-screen display before using.

Inserting or Changing the Needle

The needle that is in the machine when it arrives at
your home has been used for 20 minutes of testing. It is
possible that it could be damaged in shipping or as you
remove the machine from the box. For these reasons,
Baby Lock recommends that you replace the needle
before beginning to quilt with your new machine.
1. Move the needle bar to the highest position by
turning the handwheel.
2. Confirm that the power is turned off and that the
machine is unplugged.
3. Loosen the needle bar clamp thumb screw with the
disc-shaped screwdriver or fingers (see Figure 8)
enough to assure that the needle can be inserted all
the way up to the top of the sight hole.
Babylock.com
Figure 7
Sight
Opening
Needle
Bar
Clamp
Screw
Figure 8
Page 15