Optoma EP706 Service Manual page 34

No Symptom
4 No Light On
5 Mechanical Noise
6 Line Bar / Line De-
fect
7 Image Flicker
8 Color Abnormal
9 Poor Uniformity /
Shadow
0 Dead Pixel / Dust
(Out of spec.)
 Garbage Image
Confidential
- Ensure all connectors are securely connected and
aren't broken
- Check Lamp Module
- Check DC-DC
- Check Ballast
- Check Main Board
- Check Color Wheel
- Check Fan Module
- Check if the DMD Chip and the DMD Board are
assembled properly
- Check DMD Board
- Check DMD Chip
- Check Main Board
- Do "Reset" of the OSD Menu
- Ensure the Signal Cable and Source work
- Clean Photo Sensor Board
- Check Lamp Module
- Check Color Wheel
- Check DMD Board
- Check Main Board
- Do "Reset" of the OSD Menu
- Adjust Color Wheel Index
- Check Main Board
- Check DMD Board
- Check Color Wheel
- Ensure the Projection Screen without dirt
- Ensure the Projection Lens is clean
- Ensure the Brightness is within spec.
(Replace the Lamp if the Brightness is less
than spec.)
- Check Engine Module
- Ensure the Projection Screen without dirt
- Ensure the Projection Lens is clean
- Clean DMD Chip and Engine Module
- Check DMD Chip
- Check Engine Module
- Ensure the Signal Cable and Source work
- Check Main Board
- Check DMD Board
3-2
Procedure
EP706/709