Ariens Pro 28 Owner's Manual page 17

Discharge Chute
Discharge chute rotates 200°.
ALWAYS position discharge chute in safe
direction and angle, away from operator and
bystanders, before starting engine.
Quick-Turn Chute Control
(Figure 13)
IMPORTANT: If chute does not stay in set
position, adjust as directed in Discharge
Chute Control on page 26, or repair before
operation.
Pull lever back to unlock discharge chute and
push left or right to rotate discharge chute.
Once chute is in desired position, move lever
forward to lock chute in place. (Figure 13).
Figure 13
IMPORTANT: DO NOT force frozen chute
controls. If frozen, take to warm place until
controls are free.
Heated Hand Grips
Turn the heated handles
1
switch to the ON (1)
position to activate. Turn
the switch to the OFF (2)
position to deactivate.
2
Scraper Blade
The scraper blade allows better contact with
the surface being cleared. It also prevents
damage to the housing from normal usage.
IMPORTANT: DO NOT allow Scraper Blade
to wear too far or Auger/Impeller housing will
become damaged.
Skid Shoes
The skid shoes control the distance between
the scraper blade and the ground. Adjust skid
shoes equally to keep blade level with the
ground. Refer to Pre-Start on page 19 for
recommended settings.
Drift Cutters
(Figure 14)
Drift cutters break up snow drifts that are
taller than the auger housing and direct the
snow into the auger. Store the drift cutters on
the auger housing when not in use. Install
them as shown below so they are taller than
the snow to be cleared.
Stored Position
Operating Position
EN - 17
Figure 14