Table of Contents
Advertisement
Charging the Battery
The label maker is powered by a rechargeable, lithium polymer (LiPo) battery. The
battery, included with your label maker, is already installed and is shipped partially
charged.
A power adapter is included with your label maker for recharging the battery. Fully
charging the battery will take approximately 2.5 hours.
Lift the connector cover on the side
1
of the label maker and turn
clockwise. See Figure 4.
Plug the power cord into the power
2
adapter. See Figure 5.
Plug the power adapter into the power connector, and then plug the power cord
3
into a power outlet. See Figure 5.
Power adapter
Make sure to read the LiPO Safety Precautions found on page 11.
4
Lift and turn
clockwise
Power connector
Power cord
Figure 4
Figure 5
Advertisement
Table of Contents
