Functions
Setting the paper width
• 80 mm (initial setting)
• 58 mm
Be sure to install the roll paper guide when you select the 58 mm paper width. (See
Once you change the paper width from 80 mm to 58 mm, you cannot change it back to
Setting the print density
Selectable from "Depends On Dip Switch", or levels 1 to 13 (70% 130%)
When the print density is set to "Depends On Dip Switch" (Initial Settings), the Dip switch
settings are applied. With other settings, the customized value settings are applied.(See
"Functions" on page
Setting the multiple tone print density
Selectable from levels 1 to 13 (70% 130%) (initial setting: level 7)
First change the print density, and then configure the multiple tone print density.
If you set the density too high, the contrast becomes lower. Select the density level
Setting the print speed
Selectable from levels 1 to 13 (Slow Fast) (initial setting: level 13)
Depending on print conditions, such as print duty and print head temperature, print speed is
automatically adjusted, which may cause white lines due to intermittent print (the motor
sometimes stops). To avoid this, keep the print speed constant by setting it lower.
Setting font
• Code page: Selectable from 43 pages
• International character set: Selectable from 18 sets
• Font A/B replacement
54
"Changing the Paper Width" on page
80 mm.
31.)
checking the overall tone balance of your image.
33.)