Safety Instructions For Installation - Miele KM 6112 Operating And Installation Instructions


The appliance must only be installed and connected to the electricity sup‐
ply by a suitably qualified and competent person in strict accordance with cur‐
rent national and local safety regulations.
Fit the wall units and cooker hood before fitting the hob to avoid damaging the
hob.

The veneer or laminate coatings of worktops (or adjacent kitchen
units) must be treated with 100 °C heat-resistant adhesive which will
not dissolve or distort. Any backmoulds must be of heat-resistant
material.

The hob must not be installed over a fridge, fridge-freezer, freezer,
dishwasher, washing machine, washer-dryer or tumble dryer.

This hob must not be installed above ovens or cookers unless
these have a built-in cooling down fan.

When installing the hob, make sure that the connection cable
cannot come into contact with hot appliance parts.

The electrical cable may not come into contact with any moving
kitchen component (e.g. a drawer) or be subject to mechanical ob‐
struction which could damage it.

Observe carefully the safety clearances listed on the following pa‐
ges.
All dimensions are given in mm.

Safety instructions for installation

51