Anititheft Alarm Function Disable - Sanyo PLC-XE40 Service Manual

Anititheft Alarm Function Disable

This projector is equipped with an Antitheft alarm function which works when detecting a vibration to protect the pro-
jector from a suspicious person.
Release the alarm setting
Press the F button and input the four-digit PIN code within
10 seconds. (default PIN code "1111") When the alarm is
Side Control
released, you will hear high-pitched confirmation sound.
When inputting an incorrect PIN code, you will hear low-
pitched sound. If you input incorrect PIN codes 3 times, the
alarm will start ringing.
Reset settings (Not in the Antitheft mode on)
If you forget the PIN code to setup the alarm setting, press
the button 3 and then press the F button twice. All the
settings you have made will go back to the factory default
settings. (default PIN code "1111")
Cancelling the Antitheft mode
F button button 1, 2, 3
If you forget the PIN code to release the alarm setting, press
and hold the button 3 and F button at the same time for
more than 3 seconds. The Antitheft mode will be off and all
the settings you have made will go back to the factory de-
fault settings. (default PIN code "1111")
-7-