Features And Controls; Snowthrower Controls - Craftsman C950-52301-0 Operator's Manual

Features and Controls

A
C
B

SNOWTHROWER CONTROLS

A. Speed Select Lever — Allows the operator to select forward
and reverse speeds (see Figure 2). To shift, move speed se-
lect lever to desired position.
NOTICE: Do not move speed select lever while Traction
Control is engaged. This may result in severe damage
to the drive system.
B. Auger Control Lever — Used to engage and disengage the
auger and impeller. To engage push down, to disengage re-
lease.
C. Chute Rotation Switch — Used to rotate the discharge
chute to the left or right.
D. Deflector Control Switch — Used to control the angle of the
chute deflector (up or down).
10
K
D
J
I
E
G
F
H
E. Easy-Turn Traction Control — When engaged, allows the
TM
operator to release one drive wheel, but allows the other
wheel to continue driving for easy turning.
F. Free-Hand Control — After engaging the traction control
TM
(left hand) and auger control (right hand), allows the operator
to release the auger control lever to use the other controls.
G. Traction Control Lever — Used to propel snowthrower for-
ward or reverse. Push down to engage, release to disengage.
See also, "Free-Hand Control".
H. Clean-Out Tool — Used to remove snow and debris from the
discharge chute and the auger housing.
I. Skid Shoes — Used to adjust the ground clearance of the
auger housing.
2 2
1 1
1 2
Figure 2