Table of Contents
Advertisement
LONG TERM STORAGE
(Over 30 Days)
Do not store your unit for a prolonged period
of time (30 days or longer) without performing
protective storage maintenance which includes the
following:
1. Store unit in a dry, dust free place, out of
the reach of children and other unauthorized
persons.
2. Place ignition switch in STOP position.
3. Remove accumulation of grease, oil, dirt and
debris from exterior of unit.
4. Perform all periodic lubrication and services
that are required.
5. Tighten all the screws, bolts and nuts.
DO NOT STORE IN AN ENCLOSURE WHERE
FUEL FUMES MAY ACCUMULATE OR REACH
AN OPEN FLAME OR SPARK.
STORAGE
WARNING
6. Tighten muffl er mounting bolts (or nuts) to 80-
95 in lbf (90-110 kgf cm).
7. Start engine, and warm to operating temperature.
8. Stop engine, and re-tighten mounting bolts (or
nuts) to specifi cations.
9. Install engine cover and attach spark plug lead.
6. Drain the fuel tank completely and pull the
recoil starter handle several times to remove
fuel from the carburetor.
7. Remove the spark plug and pour 1/2
tablespoon (1/4 oz) of fresh, clean, 2-stroke
engine oil into the cylinder through the spark
plug hole.
A. Place a clean cloth over the spark plug hole.
B. Pull the recoil starter handle 2 or 3 times to
distribute the oil inside the engine.
C. Observe the piston location through the
spark plug hole. Pull the recoil starter handle
slowly until the piston reaches the top of its
travel and leave it there.
8. Install the spark plug (do not connect ignition
cable).
9. Lubricate the drill bit with a heavy coat of oil to
prevent rust.
NOTE
For future reference, you should keep this
operator's manual.
17
Advertisement
Table of Contents
