Table of Contents
Advertisement
Quick Links
OPERATOR'S MANUAL
ECHO, INCORPORATED
400 Oakwood Road, Lake Zurich, Illinois 60047-1564
Phone : 847-540-8400
ENGINE DRILL
WARNING
READ INSTRUCTIONS CAREFULLY AND
FOLLOW RULES FOR SAFE OPERATION.
FAILURE TO DO SO COULD RESULT IN
SERIOUS INJURY.
ECHO
ED-200
DANGER
Printed in Japan 0310Ami 857 ES
X750-004 56 0
X750409-3400
Advertisement
Table of Contents
Related Manuals for Echo ED-200
Summary of Contents for Echo ED-200
- Page 1 OPERATOR’S MANUAL ECHO, INCORPORATED 400 Oakwood Road, Lake Zurich, Illinois 60047-1564 Phone : 847-540-8400 ENGINE DRILL WARNING DANGER READ INSTRUCTIONS CAREFULLY AND FOLLOW RULES FOR SAFE OPERATION. FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY. ECHO ED-200 X750-004 56 0...
- Page 2 Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: • Lead from lead-based paints, •...
-
Page 3: Table Of Contents
ECHO Engine Drill ED-200 is a lightweight, high performance, two-stroke engined unit designed for drilling. This Manual provides the information necessary for operation and maintenance. SAFETY AND SPECIAL INFORMATION THIS SYMBOL ACCOMPANIED BY THE WORDS WARNING AND DANGER CALLS ATTENTION TO AN ACT OR... -
Page 4: Safety
Always wear eye protection goggles that meet ANSI Z87.1 standards. • Wear hearing protection. ECHO recommends that hearing protection be worn at all times. • Dress properly! Do not wear loose clothing or jewellery, they can be caught in moving parts. - Page 5 Spectators, children, fellow workers and animals must be warned to come no nearer than 4.6 m (15 feet) while the engine drill is in use. People working in the area near you should wear the same protective equipment as the operator.
- Page 6 Repetitive Stress Injuries It is believed that overusing the muscles and tendons of the fingers, hands, arms and shoulders may cause soreness, swelling, numbness, weakness and extreme pain in those areas. Certain repetitive hand activities may put you at a high risk for developing a Repetitive Stress Injury (RSI).
-
Page 7: Operating Techniques
• When starting to drill, run the engine at full throttle. WARNING BEFORE DRILLING, BE SURE TO READ AND UNDERSTAND THE ENTIRE OPERATOR’S MANUAL TO AVOID THE CHANCE OF SERIOUS INJURY. • Do not force the drills and only move as quickly as the drills will allow. -
Page 8: Description
3. Rear handle - Handle located furthest from the drill bit. 4. Silencer cover 5. Drill bit - Not included with unit. 6. Chuck 7. Front handle - Handle located on the front gear case. 8. Fuel tank - Contains fuel and fuel filter. -
Page 9: Assembling
10% ethyl (grain) alcohol or 15% MTBE (methyl tertiary- butyl ether). Gasohol containing methyl (wood) alcohol is not approved. OIL - ECHO brand premium two-strokes 50 : 1 oil is preferred. Mix oil and gasoline/gasohol according to Instructions on the oil container label. -
Page 10: Starting Cold Engine
Place ignition switch in STOP position. NOTE When engine does not stop, shift choke lever to close position. Check and repair ignition switch before starting the engine again. r/min. Therefore the drill bit may rotate at fast idle engine speed. -
Page 11: Maintenance And Care
MAINTENANCE AND CARE AREA MAINTENANCE Air Filter Clean/Replace Fuel Filter Inspect/Clean/Replace Spark Plug Inspect/Clean/Adjust/ Replace Carburetor Adjust Cooling System Inspect/Clean Silencer Inspect/Tighten/Clean Starter Rope Inspect/Replace Drills Inspect/Clean/Lubricate Fuel Leaks Inspect/Repair Screws, Bolts and Nuts Inspect/Tighten/Replace Fuel Line Inspect PAGE BEFORE MONTHLY •... -
Page 12: Trouble Shooting
MANUAL SHOULD BE PERFORMED BY AN AUTHORIZED ECHO DEALER. Remedy • Clean or replace • Clean • Ask your ECHO dealer • Ask your ECHO dealer • Open choke • Clean/replace air filter • Adjust carburetor • Ask your ECHO dealer •... -
Page 13: Maintenance
Air filter Air cleaner cover Fuel filter Fuel tank cap 0.6 - 0.7 mm (0.024 - 0.028 in) MAINTENANCE AIR FILTER • Clean before Use. - Remove air cleaner cover and pull out air filter. - Lightly brush off dust or wash it in water and detergent. -
Page 14: Adjusting Carburetor
1. Start engine and allow it to run at high idle until warm. 2. Turn the idle speed screw clockwise until drill bit begins to move. 3. Turn idle screw counterclockwise 1 and 1/2 to 2 turn or until the drill bit stops (2,700 to 3,300 r/min). -
Page 15: Storage
8. Install the spark plug (do not connect ignition cable.) 9. Lubricate the drill bit with a heavy coat of oil to prevent rust. NOTE For future reference, you should keep this... -
Page 16: Specifications
9,000 r/min 2,900 r/min 4,000 diaphragm type flywheel magneto - CDI system NGK BPM8Y recoil starter automatic Centrifugal Mixture of gasoline (unleaded, 89 octane minimum) and specially blended 50 : 1 ECHO two cycle engine oil. 0.47 (15.9 US,fl.oz.) ED-200...