Graco 16F887 Operation Manual page 18

Shutdown and Cleaning
8. Disengage trigger lock, reverse tip to UNCLOG
position, and pull trigger for 5 seconds to prime
sprayer.
ti14995a
ti16698a
9. Put prime/pressure relief valve DOWN to spray
position. Trigger sprayer into waste area until no
paint appears in water or flushing fluid.
ti16701a
ti15425a
10. If sprayer is not completely clean, repeat steps 4-9.
To avoid serious injury or damage to equipment, do not
expose the sprayer electronics to flushing solvents.
Keep sprayer at least 10 in. above the rim of the con-
tainer when flushing.
Keep spray area well-ventilated. Keep a good supply
of fresh air moving through the area. When flushing
with solvents, always ground the sprayer and waste
container.
18
ti14991a
ti14991
ti15491a
ti16713a
ti15529a ti16727a
11. Engage trigger lock and put prime/pressure relief
valve UP to release pressure.
ti16699a
ti14994a
12. Remove material cup and discard used fluid.
13. Use a stiff wire such as a paper clip to make sure
vent hole is open.
14. Remove Spray Tip/Guard Assembly and clean with
water or flushing fluid. A soft brush can be used to
loosen and remove dried material if needed.
ti15003a
ti15003a
The tip is permanently attached to the guard. Removing
the tip from the guard will result in damage to the tip
assembly.
Do not store tip/guard assembly or suction tube in sol-
vent other than mineral spirits. Damage to parts may
occur.
ti16700a
ti17102a
NOTICE
ti14999a
3A1698G