Operation; Starting Cold Engine; Starting Warm Engine; Stopping Engine - Echo PB-2155 Operator's Manual

O
PERATION
IMPORTANT
Check unit for loose nuts, bolts and screws daily.
IMPORTANT
Recoil starter: Use short pulls - only 1/2-2/3 of rope length for
starting. Do not allow the rope to snap back in. Always hold the
unit firmly.

STARTING COLD ENGINE

1. Move ignition switch to START/RUN position.
2. Push purge bulb 3-4 times (or until fuel is visible in fuel return line).
3. Close choke (move choke lever up) and pull starter handle until
engine fires.
4. Open choke and if necessary, restart engine.
NOTE
Allow engine to warm up before use.

STARTING WARM ENGINE

1. Move ignition switch to start, pull starter handle 1-3 times and
engine should start. Do not use choke.
NOTE
If engine does not start after 4 pulls, use cold start procedures.

STOPPING ENGINE

1. Release throttle trigger and allow engine to run at idle for a few
minutes.
2. Move ignition switch to "STOP" position.
WARNING
If engine does not stop, shift choke lever to closed position.
Check and repair ignition switch before starting engine again or
serious personal injury may result.
DANGER
P B
OWER LOWER
O ' M
PERATOR S ANUAL
START/RUN
Starter handle
Choke lever
Purge bulb
Ignition
switch
Throttle trigger
13
Ignition
switch
STOP