Trial Run - Yamaha 2009 Diversion XJ6S Service Manual

11.After the pulsating action has stopped in the
front brake pedal, it is generated in the rear
brake pedal "1" 0.5 second later and contin-
ues for approximately 2 seconds.
TIP
The reaction-force pulsating action consists of
G
quick pulses.
Be sure to continue operating the brake lever
G
and brake pedal even after the pulsating action
has stopped.
12.After the pulsating action has stopped in the
rear brake pedal, it is generated in the front
brake lever 0.5 second later and continues
for approximately 1.5 seconds.
TIP
The reaction-force pulsating action consists of
quick pulses.
ECA4B56021
NOTICE
Check that the pulse is felt in the front
G
brake lever, rear brake pedal, and again in
the front brake lever, in this order.
If the pulse is felt in the rear brake pedal be-
G
fore it is felt in the front brake lever, check
that the brake hoses and brake pipes are
connected correctly to the hydraulic unit
assembly.
If the pulse is hardly felt in either the brake
G
lever or brake pedal, check that the brake
hoses and brake pipes are connected cor-
rectly to the hydraulic unit assembly.
13.Turn the main switch to "OFF".
14.Remove the test coupler adapter from the
ABS test coupler.
15.Turn the main switch to "ON".
16.Set the engine stop switch to "
17.Check for brake fluid leakage around the hy-
draulic unit.
Brake fluid leakage → Replace the hydraulic
unit, brake pipes, and related parts as a set.
1
".
ABS (ANTI-LOCK BRAKE SYSTEM)
EAS22820

TRIAL RUN

After all checks and servicing are completed, al-
ways ensure the vehicle has no problems by
performing a trial run at a speed of faster than 30
km/h.
4-56