8. SELECTION OF MULTI-AMPLIFICATION DRIVE SYSTEM
Use the three rear panel mode switches to select the desired drive mode. Loosen the switch panel mounting
screws to operate the mode switches. Set the switches as shown below depending on the drive system used,
then retighten the mounting screws to secure the switch panel. Note that the switches are set at the factory for
single-amplifier applications.
8.1. Single-Amplification System
8.2. Dual-Amplification System
8.3. Triple-Amplification System
8
Mode switch
Mode switch
Mode switch
Mode switch position
Mounting screw
Switch panel
Mode switch position
Mounting screw
Switch panel
Mode switch position
Mounting screw
Switch panel