JVC KD-SX8250 Service Manual page 17

Removing the turn table / spindle motor
Prior to performing the following procedure, remove
the top cover, the connector assembly and the
chassis / clamper assembly.
1. Remove the two screws K
motor assembly through the slot of the turn table on
top of the body.
2. Unsolder the wire on the connector board if
necessary.
(See Fig.37 and 38)
attaching the spindle
KD-SX8250/KD-SX780
K
Fig.37
K
Turn table
Spindle motor
Fig.38
Turn table
1-17