About The Remote Control On The System; Operation Mode - Lennox GCM Series Owner's Manual

About the remote control on the system

The remote control transmits the signals to the system.
Features of the Remote Control- Door Closed
5
4
ON OFF
7
8
SET CANCEL
9
2

Operation Mode

Cooling Operation
Auto Operation
Healthy Dehumidification Operation
Heating Operation
• Cooling Model( ), Heat Pump Model(
1
2
Signal transmitter
3
4
5
6
1
6
3
10
11
7
12
8
13
9
Flip-up door
(opened)
10
11
12
13
)
START/STOP BUTTON
Operation starts when this button is pressed
and stops when the button is pressed again.
OPERATION MODE SELECTION BUTTON
Used to select the operation mode.
ROOM TEMPERATURE SETTING
BUTTONS
Used to select the room temperature.
INDOOR FAN SPEED SELECTOR
Used to select fan speed in four steps
low, medium, high and CHAOS.
JET COOL
Used to start or stop the speed
cooling. (Speed cooling operates
super high fan speed in cooling mode.)
CHAOS SWING BUTTON
Used to stop or start louver movement and
set the desired up/down airflow direction.
ON/OFF TIMER BUTTONS
Used to set the time of starting and stopping
operation.
TIME SETTING BUTTONS
Used to adjust the time. (See page 11)
TIMER SET/CANCEL BUTTONS
Used to set the timer when the desired time
is obtained and to cancel the Timer
operation. (See page 11)
SLEEP MODE AUTO BUTTON
Used to set Sleep Mode Auto operation.
(See page 11)
AIR CIRCULATION BUTTON
Used to circulate the room air without cooling
or heating. (See page 12)
ROOM TEMPERATURE CHECKING
BUTTON
Used to check the room temperature.
RESET BUTTON
Used prior to resetting time or after replacing
batteries.
5