System Expansion; Information About Boards - Fujitsu Celsius C620 Operation Manual

System expansion

As the device has to be shut down to install or remove system expansions, it is a good
i
idea to print out some parts of this section.
It may be necessary to update the BIOS when carrying out a system expansion or
hardware upgrade. Additional information is contained in the "BIOS Setup" manual or
where applicable in the technical manual for the mainboard.
When installing components that become very hot, make sure that the maximum
permissible temperature is not exceeded.
The components are very similar to each other. For this reason, the device is shown in the
following illustrations. In case of differences, this will be pointed out at the appropriate
point.
The device must be switched off when installing/removing the system expansions and
!
must not be in the energy-saving mode.
Remove the power plug from the power socket before opening the device.
This section describes all the actions which you must perform if you wish to make hardware changes
to your device (e.g. installing boards or drives).
Read the supplied documentation before installing new drives and/or boards.
Read the technical manual for the mainboard before making any expansion to the mainboard.

Information about boards

Take care with the locking mechanisms (catches and centring pins) when you are replacing boards
or components on boards.
To prevent damage to the board or the components and conductors on it, please take care when you
insert or remove boards. Make sure expansion boards are inserted in a straight manner.
Never use sharp objects (screwdrivers) for leverage.
Fujitsu Technology Solutions
Boards with electrostatic sensitive devices (ESD) can be identified by the
sticker shown.
When handling boards fitted with ESDs, you must always observe the
following points:
● You must always discharge static build up (e.g. by touching a
grounded object) before working with boards.
● The equipment and tools you use must be free of static charge.
● Always hold boards by their edges.
● Never touch connector pins or conductors on the board.
System expansion
51