AEG LAVAMAT 64810 User Information page 20

Problem
E10 appears.
END display flashes 1x,
at the same time an
acoustic signal sounds
1x.
(Problems with water
inflow)
The washing machine
vibrates when operating
or is not stable.
Washing has not been
spun.
Water is leaking out un-
derneath the washing
machine.
Washing water is foam-
ing excessively. At the
end of the washing cy-
cle, spin stops.
E20 appears.
ENDdisplay flashes 2x,
at the same time an
acoustic signal sounds
2x.
(Problems with water
outflow)
20
Possible cause
Tap turned off.
Filter in the screw connec-
tion of the inlet hose is
blocked.
Water tap is blocked with
limescale or faulty.
The transit packaging has
not been removed.
The screw feet not correctly
adjusted.
Only a few large items of
washing in the drum.
Screw connection on the in-
let hose is leaking.
Drain hose is leaking.
Drain pump cover is not
closed properly.
Washing was caught in the
door.
Emergency drain hose is
leaking.
Probably too much deter-
gent has been used.
Kink in drain hose.
Maximum pumping height
of 1m exceeded.
Drain pump is blocked.
With connection to sink
outlet: sink outlet is
blocked.
Remedy
Turn the tap on.
Turn off the water tap. Un-
screw hose, take out filter
and clean it.
Check the water tap and
have it repaired if necessary.
Removing the transit pack-
aging.
Adjust the feet as described
in the installation and con-
nection instructions.
Always load the drum as full
as possible. Mix large and
small items.
Tighten inlet hose.
Replace drain hose.
Close cover properly.
Load washing carefully for
the next wash.
Close off emergency drain
hose properly.
Dose detergent exactly as in-
structed by manufacturer.
Remove kink.
Please contact Customer
Care Department.
Switch off appliance. Pull out
mains plug.
Clean drain pump. Remove
foreign bodies from pump
housing.
Clean out sink outlet.