Fujitsu PRIMERGY TX300 S4 Start Manual page 3

Hide thumbs Also See for PRIMERGY TX300 S4:

n Fixing the power cable

To prevent the power cable from falling down, after connecting the power cable to the server, pass the supplied release tie

through the air holes and secure approximately 10 cm from the connector of the cable as shown in the figure below. When un-

plugging the cable, make sure to unplug the connector on the server end.

Turning on the power and setting hardware

Normally, hardware settings are not required to be changed.

However, in the following cases, start up BIOS Setup Utility, and check or change hardware settings.

- When changing the server boot drive

- When optional devices are installed

- When installing Windows Server 2008 (64-bit) by using ServerStart

"2.1.2 Hardware Settings", "Chapter 7 Configuring Hardware and Utilities"

You can write down hardware configuration and setting values of the BIOS Setup Utility in the "Configuration

Sheets" that is available from Fujitsu PRIMERGY website (http://primergy.fujitsu.com).

Turn on the peripheral devices, such as

a display.

Pull down the drive cover, and then

turn on the power.

��

Set the hardware.

1. When the "<F2> BIOS Setup / <F12>

Boot Menu" message appears at the server

start up (during POST), press the [F2]

key.

2. Check/change the settings.

3. From the [Exit] menu, select "Save

Changes & Exit", and press the [Enter]

key to exit BIOS Setup Utility.

Turn off the power of the server.

Table of Contents