Connecting Hoses and Power Supply
Please follow the instructions in this section to conduct operations to prevent water leak. If
you are unsure, ask a service agent to connect the hoses.
Hoses and lead lengths
Left side connections
~ 85 cm
Water-supply hose
CAUTION
- Do not connect the water-supply
hose to a combination tap.
- Do not twist, squash, modify, or
cut the hose.
- Optimum mains water pressure is
0.03 - 1.0 MPa. If the water pressure
exceeds this value, install a pressure
reducing valve.
- Water-flow from the tap should be
more than 5 L/min.
12 - Installation Instructions
NA-128VG5_New Zealand.indb 12
~ 95 cm
~ 75 cm
Right side connections
~ 125 cm
~ 40 cm
~ 125 cm
Connecting the water-supply hose
1. Attach one end of the hose to
the water inlet on the back of the
appliance and tighten the joint by
hand.
2. Attach the other end of the hose to
the tap and tighten it the same way.
3/4"
3/4"
min. 10 mm
Standard hose
3. Open the tap slowly and make sure
that there are no leaks around the
joints.
The joints are subject to water pressure.
2015-2-6 20:30:36