Sony XC-HR90 Technical Manual page 34

Command
Gain-STEP[CR]
Gain-FINE[CR]
BINNING P[CR]
BINNING[CR]
PARTIAL P[CR]
PARTIAL[CR]
AREA FR[CR]
AREA[CR]
MODE P[CR]
MODE[CR]
VERSION[CR]
Maa,dd[CR]
Maa[CR]
FRATE P[CR]
FRATE[CR]
INTEXT P[CR]
INTEXT[CR]
TERM P[CR]
TERM[CR]
Addition of camera control command
A function to save the settings using the camera control command is added.
It is applied to the cameras with the serial No. 110001 or later.
Command
AUTOSAVE P[CR]
Note
In the factory settings, the change of settings using the control command is automatically saved.
You cannot write the data greater than or equal to the specified number of times in the EEPROM to save the
settings. Therefore, when you change the settings frequently using the control command, select "AUTOSAVE 0".
The value set in the state of "AUTOSAVE 0" is not saved even if the saving method is changed to "AUTOSAVE 1"
immediately after that.
After changing to "AUTOSAVE 1", set the value again.
Parameter range
None
None
P: 0/1
None
P: 0/1
None
F: 0 to F (Hexadecimal numbers)
R: 0 to F (Hexadecimal numbers)
None
P: 0 to 3
None
None
aa: 00 to FF (Hexadecimal numbers)
dd: 00 to FF (hexadecimal numbers)
aa:00 to FF (hexadecimal numbers) Reads the user memory
P: 0 to 1
None
P: 0 to 1
None
P: 0 to 1
None
Parameter range
P: 0/1
Camera Control Command
Description
Reads the gain setting
Reads the gain setting
Sets the binning mode
0: Binning OFF
1: Binning ON
Reads the binning mode setting
Sets the partial scan mode
0: Partial scan OFF
1: Partial scan ON
Reads the partial scan mode setting
Sets the partial scan area
The parameters are indicated by hexadecimal numbers. The
number of blocks transferred at the upper high-speed is
indicated by the first digit, and the number of blocks
transferred at the lower high-speed is indicated by the second
digit. Set the area within the range of F + R < 16.
Reads the partial scan area
Sets the trigger mode.
0: OFF
1: Restart/Reset
2: Trigger Mode 1
3: Trigger Mode 2
Reads the trigger mode
Reads the version of the firmware of the camera
Writes the data indicated by the parameter in the user memory
Sets the frame rate
0: 30 fps
1: 15 fps
Reads the frame rate
Sets the synchronous mode
0: INT
1: EXT
Reads the synchronous mode
Sets the 75-ohm termination of the VD/HD input
0: 75-ohm termination OFF
1: 75-ohm termination ON
Reads the setting of the 75-ohm termination of the VD/HD
input
Description
You can select the saving method of the settings using the control
command.
1: The settings are immediately saved in the EEPROM. (Factory
settings)
0: The settings are not saved in the EEPROM. An invalid value is
returned to the command to read out the settings.
34