Command Specifications - Sony XC-HR90 Technical Manual

Command Specifications

This section describes the details of control commands available for the XC-HR90.
User control commands
Command
BRATE P[CR]
BRATE[CR]
INIT[CR]
INITIAL[CR]
SHUTTER P[CR]
SHUTTER[CR]
Gain-STEP PP[CR]
1
Gain-FINE PP[CR] 2
Note
The two configuration commands,
Parameter range
P: 0 to 6
None
None
None
P: 0 to C (hexadecimal numbers)
None
PP: 00 to 12
(hexadecimal numbers)
PP: 00 to FF
(hexadecimal numbers)
1 and 2, are related to each other, and the last executed command is enabled.
 
Camera Control Command
Description
Baud rate setting
0: 115200
1: 57600
2: 38400
3: 19200
4: 14400
5: 9600
6: 4800
The newly input baud rate is displayed and OK is displayed, and
then the baud rate is changed to the newly set one.
Displays the baud rate currently set
Resets the functions of the camera ( shutter, gain, scan mode
and trigger mode) to the factory settings
Resets the functions of the camera to the factory settings.
Functions to be reset are those stored in the user memory in
addition to the functions described above.
Shutter setting
0: OFF
1: 1/100s
2: 1/125s
3: 1/250s
4: 1/500s
5: 1/1000s
6: 1/2000s
7: 1/4000s
8: 1/10000s
9: 1/25000s
A: 1/50000s
B: 1/100000s
C: Trigger pulse width control
Reads the shutter setting
Sets the gain in units of dB.
00: 0dB
01: 1dB
02: 2dB
:
09: 9dB
0A: 10dB
:
0F: 15dB
10: 16dB
11: 17dB
12: 18dB
Sets the gain in fine units.
00: Minimum gain
:
20: 0dB (GAIN-STEP 00 compatible)
:
D0: 18dB (GAIN-STEP 12 compatible)
:
FF: Maximum gain
33