Sony XC-HR90 Technical Manual page 29

Setting the shutter speed using DIP switches
No HD/VD input (Internal synchronization)


2 µs to 250 ms
Trigger 1
Shutter speed (Te)
Internal VD 4
T:T=under 10 ms
Video out
WEN
1 This is an external input signal.

 2 The shutter speed (Te) is determined by the setting
of the DIP switches.
For details, see page 23.
3 Normal operation is resumed when the trigger pulse

width is 1/3 s or more. The trigger falling edge
restores external trigger shutter operation. At this
time, the 50 ms after the falling edge of the trigger
pulse is an external trigger input inhibition area.
There is no guarantee of operation for any trigger
input in this period.
4 The internal VD signals are output as long as there

is no external input and the HD/VD signal input/
output switch of the mode setting DIP switch on the
rear panel is set to the down position (INT).
External trigger shutter operation

2 Shutter speed (Te)
5 T:T=10 ms or more
 
990 H (Binning OFF)
495 H (Binning ON)
Normal operation 3
Trigger pulse width 3
2
5
5 An image is output when an internal VD signal falls

10 ms or more after a trigger pulse rises ( and 
in the figure). If the period from the trigger rising
edge to the internal VD falling edge (T in the figure)
is under 10 ms, it is not defined whether the image
is output for the external VD falling edge or the
image is output for the next external VD falling
edge. ( in the figure shows that the image is
output for the next internal VD). In this case, see
WEN since the image and WEN make up a pair.
Note
An image is not output correctly when the next trigger
is input before the image for the previous trigger has
been output.
Mode Setting
Mode transition state
External input
External trigger
inhibition area
shutter operation
(50 ms)

Shutter speed
(Te) 2
T:T=10 ms or
more 5

29