Table of Contents
Advertisement
described below.
VOLUME Knob is 0 to 255 range(+/- 1 or 2 error will be ok) and Leftmost Dot on,
BASS and TREBLE Knob is 0 to 25 range and
BASS makes centered Dot turns on and TREBLE makes Right most dots on
(and also has same error tolerance as VOLUME)
2.2.3 Keyboard Test
This test you can check each key of the keyboard. If any key press segment displays
corresponding Key name Key Number such as press C4, segment displays "C 4"
Each key has two key switches. Press softly(about 1/4 of the whole pressure) makes first
switch on and leftmost dot turns on, and press a key firmly make rightmost dot turns on
2.2.4 Pedal Test
During this test you can check the correctness of the built-in 3-Pedals. All pedal
displays a same value during this test. If pressed segment displays "127", if not segment
displays "0". As knob test did, dot displays current position of the each pedal. Such as
press leftmost pedal, turns leftmost dot on and so on.
2.3 Engine Diagnostic
2.3.1 Entering Diagnostic
Following buttons used in Diagnostic
• Entering Diagnostics : Press "MIDI/Pref" when power on
• Changing Menu item : "UP" and "DOWN" button
• Select and Cancel
How To Enter Diagnostic
1 Power up the device
2. All LEDs in front panel, flashed one time. If not check connection cable between
Engine Board and Front Board.
3. Press "MIDI/Pref" button and system will be entering boot block mode.
After system entering boot block, 7-Segment displays "uOS"(mean update
Operating System)
4. Then press "UP" button twice, and then Segment displays "DIG" now system
: "Electric Bass" – Cancel, "Custom" - Enter
7 PAGE
Hide quick links:
Advertisement
Table of Contents
