Usage Of Ice Maker And The Cold Water Dispenser - Haier HTD635WISS Instructions For Use Manual

Usage of Ice Maker and the Cold Water Dispenser

1. Preparation before using the ice maker and cold water dispenser:(Only for HTD635WISS)
a.) Cut the water pipe according to need, and avoid bending the water pipe too much. Usually the length
should be less than 18 ft. (5 m). If the water pipe is too long, cold water content are affected because there
is not enough water pressure.
b.) The water pipe cannot stand heat. Keep it away from heat sources.
c.) You may want to have a service engineer install the water pipe.
several times for 1 minute each. Do not press for more than 1 minute, to prevent overheating of the pad activator
e.)
therefore, make sure to connect the water pipe to a drinkable water source.
2. Precautions(Only for HTD635WISS)
a.) To prevent the pipe from freezing, do not install the water pipe in a place below 0°C
c.) After the fridge is installed, put the water supply pipe in a proper place to prevent pressing and damage.
d.)
indicator light will turn on.
At this time, we suggest going to your local authorized Haier after-sale service center
3.
20