Connecting The Water Supply Line - Haier HTD635WISS Instructions For Use Manual

Connecting the Water Supply Line

(Fig. 4-12)
Water pipe
Cut the water pipe according to need and avoid bending the water pipe too much.
Usually, the pipe length should be less than 5m. If the water pipe is too long, the cold water
Insert one end of the water supply pipe into the water inlet on the rear of the appliance (Fig.4-12).
Connect the other end into the plastic adaptor. Screw the adaptor onto a suitable 1/2" BSP
connector water outlet.
The water pressure should be between 0.l5~0.6MPa for correct operation of the cold water
dispenser .
to run until it is clear.
The water pipe cannot withstand heat. Keep it away from all heat sources.
from the outlet.
It cannot sterilise or destroy anything, so be certain to connect the water pipe to a drinkable water
source.
• After the refrigerator is installed, put the water supply pipe in a suitable place to prevent
crushing and damage.
10