Installation
6
US CA
Specifications
DIMENSIONS (FRONT VIEW)
Base Cabinet Installation
The cabinet depth from the outer edge of the face frame to the inside back of the cabinet or wall
should be at least 24" (see Fig. 04).
The Warming Drawer should be installed into a base cabinet with minimum outside dimensions
of 13-1/4" high by 30" wide by 24" deep.
Power supply required: 120Volts AC; 5 Amp min., 15 Amp maximum circuit requirement.
CUT OUT DIMENSIONS
+ –
10 1/16"
10-1/2"
29-11/16"
1-1/2" min.
to bottom
of
countertop
20"
+
25-3/4 1/16"
–
DIMENSIONS (SIDE VIEW)
1/2
1/4
Fig. 02
A 120 volt AC GFI
outlet should be
located below the
Warming Drawer
2x4's or similar
support
> –
24"
Fig. 04
28-3/16
"
25-1/16
"
23-1/2
"
"
"
POWER
CORD
9-3/4
"
Fig. 03