The laser/scanner system consists of the laser driver and the scanner motor etc. It is controlled by the signals sent from the engine controller and the video controller.

The laser driver allows the laser diode to emit light according to the LASER CONTROL signals (CNT0, CNT1, CNT2) from the engine controller or the VIDEO

signals (/VDO1, /VDO2, VDO1, VDO2) from the video controller.

Engine controller PCB

Video controller PCB

Focusing lens

Scanner motor

The laser/scanner unit of this printer utilizes a "twin beam method" (see Note). It scans two lines simultaneously with 2 laser diodes in order to realize a high-speed

laser scanning.

The operational sequence of the laser/scanner unit is described below.

1) When the video controller sends a print command, the engine controller rotates the scanner motor in order to rotate the four-sided mirror.

2) When the scanner motor starts to rotate, the engine controller forces the laser to emit light with the LASER CONTROL signal and then it starts to control the

scanner motor rotation.

3) The engine controller controls the scanner motor to rotate at a constant speed with the SCANNER MOTOR SPEED CONTROL signal.

4) The video controller sends the VIDEO signals to the laser driver PCB after the scanner motor rotation reaches its targeted speed.

5) The laser driver allows two laser diodes to emit light according to these signals.

2-2

/ACC /DEC

Cylindrical lens

Mirror

/BDO

/BDI

CNT0

BD sensor