Table of Contents
Advertisement
Crosscutting
CAUTION :
When making a crosscut, remove the rip fence from the table.
When cutting long or large workpieces, always provide adequate support
to
the sides of
the table. The support should be
a t
the same height as the table.
(1;
Loosen the wing bolt securing the sliding table.
0 )
Adjust the blade to 90 degrees to the
table surface. Adjust the miter gauge to
0 degree. Switch the tool on and move
the sliding table forward to cut the
wooden gauge.
Align the cutting line on the workpiece
with the end of the wooden gauge.
131
Adjust the depth
of
cut
a
bit higher
than the thickness of the workpiece.
Firmly hold the workpiece flush against
the miter gauge and move the sliding
table forward gently to cut the work-
piece.
Miter cutting
Adjust the miter gauge to the desired angle
( 0 to 45 degrees) and tighten the miter
gauge
installation
screws securely. Follow
the same procedure as'mentioned in
@
for
crosscutting.
19
Hide quick links:
Advertisement
Table of Contents
