Frigidaire FCFS181LQBA Instructions Manual page 5

First Steps
Front Fixed Caster Installation
Locate and aligr fixed caster (with brake lever
facing front of unit - see Figure 3) over the
same mounting holes from bracket in Figure 1
using 6 hex screws (3 for each caster). Secure
the screws snug using a 3/8" open end wrench.
Repeat this procedure for opposite corner, DO
NOT OVERTIGHTEN.
- Front
of unit
(3)
Fixed -/
caster Figure 3
Rear Swivel Caster Installation
1. Remove and discard the screws shown in
Figure 4 from each bottom corner using a
5/16" socket wrench.
Figure 4
2. Locate and align swivel caster over the
holes and install with 2 hex screws. Secure
the screws snug using a 3/8" socket
wrench. DO NOT OVERTIGHTEN.
3. On the opposite side of the swivel caster
plate, insert 2 carriage bolts through the
compressor support rail and swivel caster
plate. Use a lock nut on each bolt and
tighten securely using a 9/16" socket
wrench. See Figure 5.
(2) Carria!
lock nut Install caster
using (2)hex
screws
Swivel caster
Figure 5
4. Repeat the same procedure for the opposite
rear corner.
5. With the help of an assistant, carefully
upright the unit. Reassemble the rear
access guard with screws.
Unit will roll forward as it is tipped up,
Appliance Placement
Leave a 1" space on all sides and the back of
the cabinet for ease of installation, proper air
circulation and electrical connections. DO NOT
block the front grill on the lower front of your
appliance. Sufficient air circulation is essential
for the proper operation of your appliance.
Choose a place that is near a grounded electrical
outlet. For the most efficient operation, the
appliance should be located where surrounding
temperatures will not drop below 40OF (5oC)
or exceed 110OF (43oc). Additional compressor
heaters are not recommended.
Insulation
The insulated space of this cabinet is sealed
to maintain peak efficiency. Holes drilled in
the cabinet may destroy that seal and damage
electrical wiring located in the insulated space.
DAMAGED ELECTRICAL WIRING OR WET
INSULATION CAUSED BY DRILLING WILL
VOID THE WARRANTY,
5