Frigidaire FCFS181LQBA Instructions Manual page 4

First Steps
Tools Needed
The following tools are required to assemble and install the casters to the unit:
5/16", 3/8" and 9/16" Adjustable Phillips
Socket or Open End Wrench Wrench or Screwdriver
Pliers
Uncrating and Set=up
1. Remove carton and all loose parts from
inside the unit.
2. Remove the rear access guard and place
it and the screws in a safe place for
reassembly later.
3. Using an assistant, carefully tip the unit
onto its back and rest on blocks to avoid
damaging the condensate drain hose
and the plastic raceway that covers the
evaporator tubing on the back of the
cabinet.
4. Remove and discard the two front brackets
with leg leveler using a 5/16" socket
wrench. See Figure 1.
5. FOR GLASS DOOR MODELS ONLY - Remove
bottom door support bracket and screw
opposite the door hinge using a 3/8" socket
wrench. See Figure 2.
Door
support
bracket
Figure 2
Door Swing Reversal
In order to reverse door, order service kit from Frigidaire Commercial Service Center
at 1-866-738-1640.
For right hand swing doors, order kit #5304488173.
For left hand swing doors, order kit #5304487215.
4