Zanussi ZWG 680K User Manual page 12

Detergent dispenser
To clean the dispenser:
1.
3.
5.
The inlet hose filter and the valve filter
To clean the water inlet filters:
1.
1
2
3
12
2.
4.
6.
2.
3.
Frost precautions
If the appliance is installed in an area where the
temperature can be less than 0 °C, remove the
remaining water from the inlet hose and the
drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Remove the water inlet hose
4. Remove the drain hose from the rear
support and unhook it from sink or spigot
5. Put the ends of the drain and inlet hose
in a container. Let the water flow out of
the hoses.
6. When no more water flows, install the in-
let hose and the drain hose again.
Warning! Make sure that the temperature
is more than 0 °C before you use the
appliance again.
The manufacturer is not responsible for
damages caused by low temperatures.
4.
45°
20°
www.zanussi.com