Bissell 58F8 Series User Manual page 12

ntenance and care
Replace headli_lht
1. Turn power OFF. Unplug vacuum from
electrical outlet.
2. Using a flat screwdriver or coin, insertinto
the sloton the right of the lensand gently
push inner latch to the leftto remove the lens.
3. Pullold Bulb straight out of socket. Pushnew
Bulb straight into socket until locked into
place.
4. Reposition lens By inserting the tab on
the left side and then pushing the right
side Back into place.
TurboBrush Tool maintenance
Select models include Pet TurboEraser
Tool Ihat follows same maintenance
instructions.
I. Turn power OFF. Unplug vacuum cord
from electrical outlet.
2. Turn tool so bottom side faces up and
remove the two screws.
3. Remove the faceplate and clear any
obstructions
4. Remove the brush from the drive belt to
clean debris.
5. Reposition the drive belt on the brush,
and place ends of brush in slots on the
side. Reposition faceplate and secure
with two screws.
12
www.bissell.com 800.237.7691