Whirlpool 1CWTW4740YQ1 Use And Care Manual page 10

Excessive Weight Hazard
Use two or more people to move and install washer.
Failure to do so can result in back or other injury.
TRANSPORTING YOUR WASHER
1. Shut off both water faucets. Disconnect and drain water
inlet hoses.
2. If washer will be moved during freezing weather, follow
Winter Storage Care directions before moving.
3. Disconnect drain from drain system and drain any
remaining water into a pan or bucket. Disconnect drain hose
from back of washer.
4. Unplug power cord.
5. Place inlet hoses and drain hose inside washer basket.
6. Drape power cord over edge and into washer basket.
7. Place packing tray from original shipping materials back inside
washer. If you do not have packing tray, place heavy blankets
or towels into basket opening. Close lid and place tape over
lid and down front of washer. Keep lid taped until washer is
placed in new location.
r
RE! NSTALLING/USI NG WASHER AGAI N
To reinstall washer after non-use, vacation, winter storage,
or moving:
1. Refer to Installation Instructions to locate, level, and
connect washer.
2. Before using again, run washer through the following
recommended procedure:
To use washer again:
1. Flush water pipes and hoses. Reconnect water inlet hoses.
Turn on both water faucets.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
2. Plug in washer or reconnect power.
3. Run washer through Casual or Casual Regular cycle to
clean washer and remove antifreeze, if used. Use half the
manufacturer's recommended amount of detergent for a
medium-size load.
10