Advertisement
Removing Old Trimming Line and Obstructions
If necessary, remove any old trimming line and/or obstructions
from
the cutting head.
1. Firmly press in the tabs on the cutting head (Fig. 16).
2. Remove the spool cover (Fig. 16).
3. Remove any old trimming line and/or obstructions.
4. Use a clean cloth to clean the inner reel, outer spool and spool
cover (Fig. 16).
5. Align the tabs on the spool cover with the holes on the outer
spool (Fig. 16). Push the spool cover onto the outer spool until
the tabs securely snap into the holes.
Y
Fig. 17
CHECKING THE OiL LEVEL
_
ARNING:
OVERFILLING THE CRANKCASE MAY
CAUSE SERIOUS PERSONAL iNJURY. Check the oil level
before each use. The importance of maintaining the proper
oil level cannot be overemphasized.
1. Stop the engine and allow it to cool.
2. Set the unit on a fiat, level surface,
such as a workbench or
table. The cutting head shield should hang over the edge so that
the engine is level (Fig. 17).
NOTE: Failure to keep the engine level may cause the oil to overfill.
3. Clean the area around the oil fill plug (Fig. 18) to prevent debris
from entering the oil fill hole.
4. Unscrew the oil fill plug.
5. Look into the oil fill hole; use a flashlight if necessary. The oil
level should just touch the bottom
thread of the oil fill hole
(Fig. 19). If the oil level is too low, add oil to the oil fill hole until
the oil level touches the bottom thread of the oil fill hole.
NOTE: DO NOT overfill the crankcase.
6. Wipe up any oil that may have spilled.
7. Reinstall the oil fill plug.
NOTE: Make sure the O-ring is in place on the oil fill plug (Fig. 18).
CHANGING
THE OiL
Change the oil while the engine is still warm. The oil will flow freely
and carry away more impurities.
1. Clean the area around the oil fill plug (Fig. 18) to prevent debris
from entering the oil fill hole.
2. Unscrew the oil fill plug.
3. Tip the unit vertically to pour the oil out of the oil fill hole and into
a container (Fig. 20). Allow ample time for complete drainage.
NOTE: Dispose of the old oil according to federal, state and local
regulations.
4. Wipe up any oil that may have spilled.
5. Pour 3.04 fl.oz. (90 ml) of SAE 30 oil into the oil fill hole.
NOTE: DO NOT overfill. Refer to Checking the Oil Level.
NOTE: Use the empty oil bottle saved from the initial use to
measure the correct amount of oil. Fill the oil bottle to the 3.04 fl.
oz (90 ml) fill line indicated on the back of the bottle (Fig. 21).
6. Wipe up any oil that may have spilled.
7. Reinstall the oil fill plug.
NOTE: Make sure the O-ring is in place on the oil fill plug (Fig. 18).
O-Ring
Oil Fill Hole
Bottom
Thread
Fig. 18
Fig. 19
Fig. 20
Maximum
Oil Level
14
Advertisement
