GE PGS25KSEAFSS Owner's Manual And Installation Instructions page 21

Installation Instructions
INSTALLING THE REFRIGERATOR
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature will
go below 60°F(16°C)because it will not run often enough
to maintain proper temperatures,
• Do not install the refrigerator where the temperature will
go above 100°F(37°0)because it will not perform properly,
• Install it on a floor strong enough to support it fully loaded,
CLEARANCES
Allow the following clearances for ease of installation, proper
air circulation and plumbing and electrical connections,
Standard Depth Counter Depth
Models Models
Sides 1/8" (3 mm) 1/8" (3 mm)
Top 1" (25 mm) 1" (25 mm)
Back 2" (50 mm) 2" (50 mm)
REMOVE TOPCAP(on
some models)
• IMPORTANT NOTE:This refrigerator is 34-I/2" deep.
Doors and passageways leading to the installation
location must be at least 36" wide in order to leave the
doors and handles attached to the refrigerator while
transporting it into the installation location. If
passageways are less than 36", the refrigerator doors
and handles can easily be scratched and damaged.
The top cap and doors can be removed to allow the
refrigerator to be safely moved indoors. Start with Step A.
• If it is not necessary to remove doors, skip Step A. Leave
tape and all packaging on doors until the refrigerator is
in the final location.
• SKIDREMOVAL: T ilt refrigerator to each side to remove
skid.
• NOTE:Use a padded hand truck to move this refrigerator.
Place the refrigerator on the hand truck with a side
against the truck. We strongly recommend that TWO
PEOPLE move and complete this installation.
[_ Locate and remove the two Phillipshead screws on the
top of the refrigerator, Removethe two screws on each
side at the rear of the top cap,
Lift off and remove top cap,
FB] Removethe fresh-food door, Refer to Steps 1 through 3
of "Reversingthe Door Swing" section,
r_ Removethe bottom freezer drawer, Referto "Removing
FreezerDrawer" section,
rD-1 Move refrigerator to the installation location,
REMOVETOP CAP (cont.) (on
some models)
REINSTALL DOORS,DRAWERS AND TOPCAP
r_ Carefully lower the door onto the center hinge, Reinstall
top hinge, NOTE:Ensurethe door is properly aligned to
the case top to avoid readjustment of the door during
top cap reinstallation,
[] Placecap over the top of the refrigerator, Reinstallthe
original screws in the top and back of the cap,
r_ Reinstallthe bottom freezer drawer, Refer to "Replacing
the FreezerDrawer" section,
A
Top Hinge B
[] CONNECTING THE REFRIGERATOR TO
THE HOUSE WATER LINE
(icemaker and dispenser models)
A cold water supply is required for automatic icemaker
operation, If there is not a cold water supply,you will
need to provide one, See/nstalling the _ater Line
section,
NOTES:
• Before making the connection to the refrigerator, be
sure the refrigerator power cord is not plugged into
the wall outlet,
If your refrigerator does not have a water filter, we
recommend installing one if your water supply has
sand or particles that could clog the screen of the
refrigerator's water valve, Install it in the water line
near the refrigerator, If using GESmartConnecfM
Refrigerator Tubing Kit,you will need an additional
tube (WXOSX10002)to connect the filter, Do not cut
plastic tube to install filter,
21