Frigidaire FFRH1222Q20 Use & Care Manual page 9

Operating Instructions
(continued)
REMOTE SENSING FEATURE
(on some models):
DoTis
PRESS REMOTE
SENSING
|STARTBU ON
LIGHT pulsing ( On & Off intermittently ), $t_ - ....
air L econ sensing
fan only
timer MODE V ON-OFF
NOTE: Unit display shows the set temperature
NOTE: Remote display
is actual temperature
Note: This feature can be activated from the remote control ONLY, the unit must be in a cooling mode, at remote control only
To activate the remote sensing feature, point the remote control towards the unit and press the remote sensing Start button, Next, use
the" A V "buttons to set the desired temperature at the remote, (Note that the set temperature will only be displayed on the unit
itself 1, The LIGHT on the unit control will pulse to indicate it received the signal, The LIGHT on the remote control will pulse each time it
sends a signal, It will periodically send this signal until the feature is deactivated by pressing the remote sensing Stop button, If the unit
does not receive the remote sensing signal during any 3 minute interval, the unit will beep to indicate the remote sensing mode has
ended, The display on the remote control indicates the temperature at the remote ONLY,
NOTE: The Remote Sensing function is terminated either by using the Remote Sensing Stop button or the main ON/OFF button on the unit,
HEATING FEATURE(on some models):
heat temp/timer
dean . cool remote
_a, On nnly ....
ing
air
timer MODE V ON-OFF
y
l Do THIS;
PRESS MODE BU_ON,
CHOOSE HEAT
FAULT CODES;
3
temp/timer 1
ON-OFF ]
temp/timer
F
ON=OFF
YOU WILL SEE:
Note: This feature can be used with any combination of FAN
Speeds (Low speed only on 115V models), Timer, or Sleep
Modes. When in the "Heat" mode,the fan will run continuously
while heat is needed. The temperature will automatically be
maintained anywhere between 55 °F(13 °C) and 80 °F(27 °C)
(The upper limit of temperature could reach 86°F(30 °C) on some
of the 115V models.). When the room set temperature is satisfied,
the fan will cycle off and on to circulate and sample the room air.
temp/timer
F
ON-OFF
3
temp/timer F I
ON-OFF
temp/timer
ON-OFF
If the display reads "HS", "AS", "ES', "CS" or "OS", a sensor has failed. Contact your Authorized Frigidaire Service Center.
©2009 Electrolux Home Products, Inc. All rights reserved.