Using Smartdiagnosis - LG DLEX8501 Series Owner's Manual

USING SMARTDIAGNOSIS rM
47
USING SMARTDIAGNOSlSTM
NOTE
- Only use this feature when instructed to do so by the call center. The transmission sounds similar to a fax
machine, and so has no meaning except to the call center.
- SMARTDIAGNOSIS
TM
cannot be activated if the dryer does not power up. If this happens, then troubleshooting
must be done without SMARTDIAGNOSIS
TM.
If you experience problems with your dryer, call 1-800-243-0000 (1-888-542-2623 in Canada). Follow the call center agent's instructions,
and do the following steps when requested:
to turn on the dryer. Do not press any
1. Press other buttons.
2. When instructed to do so by the call center agent, place the mouthpiece of your phone very close to the POWER button.
3. Pressand hold TEMRCONTROLbutton for three seconds, while holding the phone mouthpiece to the icon or POWERbutton.
4. Keep the phone in place until the tone transmission has finished. This takes about 6 seconds, and the display will count down the
time.
, For best results, do not move the phone while the tones are being transmitted and do not touch the control panel with the phone.
, If the call center agent is not able to get an accurate recording of the data, you may be asked to try again.
, Pressing the POWERbutton during the transmission will shut offthe SMARTDIAGNOSIS
TM.
,5.Once the countdown is over and the tones have stopped, resume your conversation with the call center agent, who will then be able
to assist you using the information transmitted for analysis at the call center.